【#Paralegal简历工作经历(2篇)#】如何撰写一份既能展现自己专业技能,又能突显个人特色的简历? 以下是小编整理的Paralegal简历工作经历(2篇),同时,幻主简历网还提供精美简历模板以及简历在线制作工具,欢迎大家阅读参考。

Paralegal简历工作经历(一)
202x.x-202x.x xxxx有限责任公司 Physical Layer FPGA Engineer
- Wireless private network project for State Grid
- (2016.3-2017.1)
1. Schematics design and PCB layout of wireless communication products(LCM,
- CPE,
- etc.)
- for various state grid standards by Cadence software.
2. Use signal generator,
- spectrum analyzer and MATLAB to analyze the wireless signal characteristicsof each communication products(signal sensitivity,
- SNR,
- SER,
- etc.).
- 230MHz LTE Split Base Station project
- (2017.2-2018.4)
1. This project is to design the LTE private wireless base station
- (230MHz)
- for the State Grid of China.
2. As the director of baseband algorithm,
- responsible for FPGA baseband algorithm design and interface development of several LTE base station BBU cards.
3.Responsible for all design of CPLD on board,including watchdog chip reset control,temperature monitoring chip control and DSP chip start and error feedback.
4. Use vivado for RTL development of FPGA on board.
- Responsible for baseband FFT/IFFT,
- AGC,
- power and other related calculations.
- The simulation is on Modelsim and the hardware platform is Xilinx Kintex-7 chip.
- CNN accelerated computing AI
- chip(2018.4-2018.12)
1. Design of new architecture of convolutional neural network for AI chip.
2. In view of the long setup time of systolic data in Google TPU,
- we use Network on Chip design method to optimize the architecture.
- Make data flows between modules can reduces signal fan out,
- improves the efficiency of MACC calculation,
- and reduces the preparation time before calculation.
3. This design adopts16 layer Vgg networkandXilinx VU9P evaluation board to verificate.
Paralegal简历工作经历(二)
202x.x-202x.x xxxx有限责任公司 Modem FPGA Engineer
- Verizon FDD Base Station MMU
- project(2019.3-2019.11)
1. FDD base station project developed by Samsung Electronics for Verizon Telecom,
- USA.
2. The main work is to upgrade features in the physical layer from LTE to NR.
- Mainly responsible for beamforming calculation,
- IFFT,
- DDUC and FIR filter by RTL design and verification on MMU FPGA.
- Matlab is used to simulate signals and insert the ILA core and dump data to verify on actual board.
- Xilinx Versal ACAP assessment
- project(2019.11-2020.3)
1.The purpose of the project is to evaluate whether ACAP can replace FPGA for development on physical layer.
2. Develop and evaluate the
32. antenna beamforming calculation based on Xilinx Versal ACAP acceleration platform.Use Xilinx Vitis software to develop AIE kernel calculation(C++)based on VC1902 ACAP platform.
3. The results that calculated by AIE are sent to the PL side(FPGA),
- and captured on the PL sidethrough ILA core for performance and resource assessment.
- Marvell modem SOC project(2020.3-present)
1. The project based on a baseband physical layer modem SoC platform customized by Marvell for Samsung.
2. Responsible for the development of SRS HAB for uplink detection channel.
- The development language is C/C++.
- The main work include SRS ZC sequence selection and analysis,
- channel report generation and job descriptor design.
- The module is debugged on the board after being simulated by Hostsim and ASIM software simulation platform.
简历在线制作下载(传送门):立即在线制作
【Paralegal】相关文章: